The C800/800+ Specification and Installation : Installing the CTERA C800
  
Installing the CTERA C800
To install the CTERA C800:
1 Install at least one hard drive in the C800.
See Installing a SATA Hard Drive in the CTERA C800.
2 Connect one end of an Ethernet cable to a Gigabit Ethernet port, and connect the other end to your Ethernet LAN switch or hub.
3 Connect a provided power supply cable to the AC power input socket of Power Supply 1, and connect the other end to the wall outlet.
4 Connect a provided power supply cable to the AC power input socket of Power Supply 2, and connect the other end to the wall outlet.
Note: The C800 should normally be used with two power cords. If both power supplies are installed but one is not connected to power, the unit assumes there is a power supply problem, and starts beeping until you dismiss the warning by pressing the Mute Alarm button on the rear panel.
5 Turn the power switch on the front of the C800 to the ON position.
The C800 will start up, and the Power LED will turn green.
The C800 automatically obtains an IP address using DHCP.
Note: If a DHCP server is not available, then after one minute, the C800 will use the IP address 192.168.192.5.
Warning: If you need to unplug the C800, you must first shut it down as described in Shutting Down the CTERA Cloud Storage Gateway. Failure to do so could result in data loss.